Base System Performance Summary

For performance comparisons, we'll turn to AnandTech’s Bench; while the individual components aren't identical to our budget system builds, in most cases the difference is small enough to not matter. Bench doesn't have the AMD Athlon II X2 250, so we've used the 255 for this comparison (the 3.3% clock speed difference is negligible). Here's how the two CPUs compare, again using standardized components—in most cases faster components than what we're using in our budget builds, but we'll discuss some upgrades in a moment.

The two chip makers’ products perform similarly, with the Pentium edging out the Athlon II in more benchmarks than the Athlon II edges the Pentium. However, in terms of real-world general usage, the two systems are similar. The AMD system is about $50 less expensive, and is therefore the recommended build. That said, we can always use the $50 for an upgraded CPU, like the Athlon II X4 640; that results in a system that handily bests the G6950. (Note that Bench doesn’t have the 640, so the 645 is used instead—another marginal 3.3% clock speed difference.) Thus, at just under $500, the quad-core AMD system is strongly recommended. Intel still edges out AMD in power consumption, but $10 or so per year for 24/7 use is hardly worth mentioning—the Intel setup might "pay for itself" in power savings eventually, but you'll probably want to upgrade again before you reach that point.

CPU Upgrades

AMD offers five compelling CPU upgrades to the Athlon II X2 250. The Athlon II X3 435 is only $11 more expensive; for that $11 you gain an extra core, though each core is very slightly slower at 2.9GHz instead of 3GHz. Unless your budget is seriously constrained, or you’re concerned about the slightly greater amount of heat produced (it’s a 95W TDP chip while the X2 250 is a 65W chip), the X3 is an excellent upgrade. As mentioned above, the Athlon II X4 640 is a quad-core processor and $39 more expensive than the X2 250.

Moving into the higher cost/performance realm, the Phenom II X4 955 Black Edition appeals to overclockers and performs better than the Athlon II X4 640, and is about $80 more than the base system’s X2 250. The least expensive, lowest clocked Black Edition CPU will typically overclock as well as the more expensive options, so there’s no real reason to go above the 955 BE. Finally, AMD offers hex-core CPUs starting at $180 ($120 more than the X2 250). The Phenom II X6 1055T is not unlocked like the Black Edition 1090T, but if you’re not overclocking there’s no reason to spend the extra $20; at stock speeds, they’ll perform very similarly. Thuban CPUs definitely aren't budget parts, so unless you're interested in some serious number crunching (or video encoding, 3D rendering, etc.) we'd draw the line at the 955 BE. Anyway, you can check Bench to see whether any of the above upgrades are worth the extra cost given your needs.

Intel offers only a few CPU upgrades that even remotely qualify for the budget range. At the very bottom is the i3-550 for $130, or there's the slightly faster i3-560 for $150; that's $30 and $50 more than the G6950, respectively. While we don't have either of those i3 models in Bench, you can see that the older i3-540 offers substantially better performance than the G6950. The i3-550 is clocked 4.5% faster than the 540 and the i3-560 is clocked 9% higher, so the gap would be slightly larger than what the Bench link shows. For a 30-50% higher cost the performance gain is nowhere near as large; on the other hand, the 10-20% increase goes well with a 5-10% increase in total system cost.

The other Intel CPU alternative is the i5-760, priced at around $210. That's $110 more expensive than the G6950, but it offers incredible computational power while sipping power relative to the higher-performing AMD CPUs. Of course, you'll also need to add in the cost of a discrete GPU, so you're looking at around $250 minimum for this upgrade. While some of these CPU upgrades are interesting, if you're looking at anything more than a budget Intel setup you're probably better off waiting for the Sandy Bridge chipset bug to get sorted out (which would also remove the need for a discrete GPU).

If you go with the most expensive AMD processor (Phenom II X6 1090T) and the same for Intel (i5-760), you're looking at a total cost of $570 for AMD compared to $581 for Intel. The two processors are pretty evenly matched, with the Intel chip pulling ahead in single core tasks and the 1090T defeating the i5-760 in tasks that can use multiple cores. Note that the i5-760 uses much less juice, so unless you are an incredibly intensive multi-tasker or use mostly multi-threaded applications, the i5-760 would be the better buy (or as mentioned, wait for Sandy Bridge to come back).

Basic System Builds Graphics, Power, and Storage Upgrades
Comments Locked

58 Comments

View All Comments

  • jonp - Monday, February 14, 2011 - link

    not me, i build systems for others and you can't deliver it without the OS. it's integral to the cost of the system. along with the power cord some have also commented on.
  • kevith - Monday, February 14, 2011 - link

    Yep...
  • HangFire - Tuesday, February 15, 2011 - link

    It's a hard cost, keep it.
  • Icabus - Monday, February 14, 2011 - link

    On the Base System Performance Summary page under the CPU Upgrades section:

    AMD offers five compelling CPU upgrades to the Athlon II X4 250.

    This should be the X2 not the X4.
  • SmCaudata - Monday, February 14, 2011 - link

    When you talk about the i5-760 you don't mention the need for a discrete video card. Doesn't seem like an upgrade option you should mention in this budget segment.
  • JarredWalton - Monday, February 14, 2011 - link

    True. I've updated the text just to make this clear. We really aren't recommending anyone go out and buy an i5-760 right now. It's a fine CPU, but for the cost and features, I would much rather wait a month or so and get Sandy Bridge -- which has an IGP as well.
  • geniekid - Monday, February 14, 2011 - link

    In general, I think AT is second to none as far as tech websites go. But, for system building, I think I still have to give the nod to Tom's Hardware and it's System Builder Marathons because they actually assemble their machines and bench them. Don't get me wrong. AT's bench is an invaluable resource, but if I'm dropping that much money to build a new machine based on the recommendations of an online article, I feel a lot more confident if the article writers actually built the thing.
  • Gigantopithecus - Monday, February 14, 2011 - link

    Hi geniekid - Zach here, thank you for your feedback. I agree that giving actual numbers from actual benchmarks, and probably also pictures of the finished systems as well, would be more effective than simply assuring you that I've built all of these systems for friends and know what they can do, and that they can do it well. ;) I'll keep that in mind if I'm asked to write more guides in the future.
  • trogthefirst - Tuesday, February 15, 2011 - link

    Right on!
  • Vincent - Monday, February 14, 2011 - link

    I was surprised to see the article recommend OCZ Vertex 2 SSDs in light of the recent controversy over the switch to slower 25nm NAND flash. Basically they switched the type of chips they used and now the drives are slower. This thread has more details

    http://forums.anandtech.com/showthread.php?t=21421...

    Clearly, the new drives' slower speeds will still blow away a mechanical drive, but this move by OCZ and their response to customer complaints hurts their reputation.

    I know that Anand has been very complimentary toward OCZ when at the same time he has had very strong pro-consumer words about Intel's handling of their chipset issues. It would be nice to see Anand's take on the OCZ issue and to see him encourage OCZ to respond better to consumers.

Log in

Don't have an account? Sign up now